TD 92579EN
15 February 2012 / Ver. H
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
91
2 Select frequency area in the Frequency drop-down list.
3 Click "OK".
4 Reset in order to make the changes take effect, see 8.22 Reset on page 138.
8.5.7 Enable Carriers
The IPBS/IPBL has 5 carriers for the North American frequency band and 10 carriers for the
other frequency bands. Under all normal circumstances all carriers should be enabled.
To enable or disable carriers:
1 Select DECT > System.
NOTE: To access the System tab, the Master mode has to be activated, see 8.5.13
Select Mode on page 94.
2 Select/clear the Enabled Carriers check boxes.
3 Click "OK".
8.5.8 Local R-Key Handling
With this option enabled keypad information is handled locally. If this option is disabled
keypad information is sent transparently to the IP-PBX. Local R-key handling is further
described in Appendix C.
1 Select DECT > System.
NOTE: To access the System tab, the Master mode has to be activated, see 8.5.13
Select Mode on page 94.
2 To enable, select the Local R-Key Handling check box.
NOTE: To access the Local R-Key Handling check box, the SIP protocol has to be
selected on the Master, see
8.5.16 Configure Gatekeeper on page 95.
3 Click "OK".
8.5.9 No Transfer on Hangup
If enabled it will not be possible to do a transfer by hanging up the handset. R4 must be
pressed (see Appendix C).
1 Select DECT > System.
NOTE: To access the System tab, the Master mode has to be activated, see 8.5.13
Select Mode on page 94.
2 To enable, select the No Transfer on Hangup check box.
3 Click "OK".
8.5.10 Configure Coder
Select the preferred coder, and enter the desired frame length. If exclusive is selected for
the coder the IPBS/IPBL is forced to use that coder. With Silence Compression enabled no
information is sent during pauses in the conversation, this is used to save bandwidth.
Note: When exclusive is enabled for a coder it might be impossible to make calls outside
the IP-DECT system.
To Next Page
Loading...
Need help?
General
