TD 92579EN
15 February 2012 / Ver. H
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
125
2 For the interface, that you want to add a CGPN map, click the “->” sign under the
CGPN map heading.
A new window opens.
Figure 29.
Figure 31. Number In – Number Out
3 Under “Number in” define the number type and –prefix that you wish to have
r
eplaced. The number type is denoted using the abbreviation from the Call Number
Formats Table (see Ca
ll Number Formats Table on page 119).
4 Define the substitution under “Number out”.
5 Click “OK”.
Note: A
ll call numbers in IP-DECT are always processed in “unknown” format. That is why
the result of a number replacement for incoming calls, always is of the type “unknown”
and the call number type of outgoing calls to be replaced is likewise always “unknown”.
Accordingly, you cannot specify a number type for replacements of incoming numbers in
the “Number out” field and for replacements of outgoing numbers in the “Number in”
field.
8.13.6 Show Active Calls
Select Gateway > Calls.
On th
is page you can see the currently active calls on all configured gateway interfaces.
Calls from the IP-DECT Master does not normally display here.
The individual columns are explained in the table below.
Column Format Values Description