TD 92579EN
15 February 2012 / Ver. H
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
53
3 Configure LDAP user name and password, select the Write Access check box, see
8.4.1 Configure LDAP Server on page 82.
4 Set a static IP address and set DHCP to off, see 8.2.2 Set a Static IP Address on page
80.
5 Set the mode to Master, see 8.5.13 Select Mode on page 94.
6 Perform a reset to restart the IPBS/IPBL in Master mode, see 8.22 Reset on page
138.
7 Select system name and password, see 8.5.1 Change System Name and Password
on page 89.
8 Set default language, see 8.5.5 Set Default Language on page 90.
9 Select supplementary services, see 8.5.12 Configure Supplementary Services on
page 92.
10 Set Master id, see 8.5.14 Set Master Id on page 94.
11 Enter gatekeeper IP address or ID, see 8.5.16 Configure Gatekeeper on page 95.
12 Connect to a Mobility Master, see 8.5.21 Connect Master to a Mobility Master on
page 98.
13 Enter IMS3 IP address, see 8.7.1 Configure Messaging on page 103.
14 Enter the Time Server address, see 8.1.5 Configure the NTP Settings on page 68.
15 Reset in order to make the configuration changes take effect, see 8.22 Reset on
page 138.
7.9 Configure the Standby Master
It is recommended to have a Standby Master in the IP-DECT system. This section describes
how to configure a Standby Master. Each configuration step is briefly described in the step
list below, for more detailed information see the corresponding subsection in 8 Operation
on page 60.
1 Determine the address and access the GUI, see 7.2 Access the GUI on page 42.
2 Change the default password, see 7.2.2 Change the Default Password on page 44.
3 Configure LDAP replicator, enter the IP address, user name and password to the
LDAP server. Alternative LDAP server must not be entered. Select the Enable check
box, see
8.4.3 Configure LDAP Replicator on page 83.
4 Set a static IP address and set DHCP to off, see 8.2.2 Set a Static IP Address on page
80.
5 Set the mode to Standby Master, see 8.5.13 Select Mode on page 94.
6 Perform a reset to restart the IPBS/IPBL in Standby Master mode, see 8.22 Reset on
page 138.
7 Enter system name and password, this should be the same system name and
password as in the Master. See
8.5.1 Change System Name and Password on page
89.
8 Select supplementary services, see 8.5.12 Configure Supplementary Services on
page 92.
9 Set Master Id, see 8.5.14 Set Master Id on page 94.
10 Enter gatekeeper address, see 8.5.16 Configure Gatekeeper on page 95.
11 Connect to a Mobility Master, see 8.5.21 Connect Master to a Mobility Master on
page 98.
To Next Page
Loading...
Need help?
General
