TD 92579EN
15 February 2012 / Ver. H
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
52
22 Assign PARI, see 8.5.25 PARI on page 99.
23 Enter SARI, see 8.5.26 SARI on page 100.
24 Enter IMS3 IP address, see 8.7.1 Configure Messaging on page 103.
25 Enter the Time Server address, see 8.1.5 Configure the NTP Settings on page 68.
26 Reset in order to make the configuration changes take effect, see 8.22 Reset on
page 138.
7.7 Configure the Standby Pari Master
It is recommended to have a Standby Pari Master in the IP-DECT system. This section
describes how to configure a Standby Pari Master. Each configuration step is briefly
described in the step list below, for more detailed information see the corresponding
subsection in 8 Operation on page 60.
1 Determine the address and access the GUI, see 7.2 Access the GUI on page 42
2 Change the default password, see 7.2.2 Change the Default Password on page 44.
3 Configure LDAP replicator, enter the IP address, user name and password to the
LDAP server (Pari Master). Alternative LDAP server must not be entered. Select the
Enable check box, see
8.4.3 Configure LDAP Replicator on page 83.
4 Set a static IP address and set DHCP to off, see 8.2.2 Set a Static IP Address on page
80.
5 Set the mode to Standby Master, see 8.5.13 Select Mode on page 94.
6 Perform a reset to restart the IPBS/IPBL in Standby Master mode, see 8.22 Reset on
page 138.
7 Enter system name and password, this should be the same system name and
password as in the Pari Master, see
8.5.1 Change System Name and Password on
page 89.
8 Select supplementary services, see 8.5.12 Configure Supplementary Services on
page 92.
9 Set Master Id, see 8.5.14 Set Master Id on page 94.
10 Enable Pari function, see 8.5.15 Enable PARI Function on page 94.
11 Enter gatekeeper address, see 8.5.16 Configure Gatekeeper on page 95.
12 Connect to a Mobility Master, see 8.5.21 Connect Master to a Mobility Master on
page 98.
13 Enter IMS3 IP address, see 8.7.1 Configure Messaging on page 103.
14 Enter the Time Server address, see 8.1.5 Configure the NTP Settings on page 68.
15 Reset in order to make the configuration changes take effect, 8.22 Reset on page
138.
7.8 Configure the Master
This section describes how to configure the Master. Each configuration step is briefly
described in the step list below. For more detailed information see the corresponding
subsection in 8 Operation on page 60.
1 Determine the address and access the GUI, see 7.2 Access the GUI on page 42.
2 Change the default password, see 7.2.2 Change the Default Password on page 44.
To Next Page
Loading...
Need help?
General
