TD 92579EN
15 February 2012 / Ver. H
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
155
Appendix C: Local R-Key Handling
Local R-key handling assume that the check box for local R-key handling is selected, see
8.5.8 Local R-Key Handling on page 91.
The following R-key functions are available during a call.
Key Description
R Put the ongoing call on hold and get a new line. (Dial the number to
the second call.)
R0 Send busy signal to the incoming call.
R1 Terminate the ongoing call and switch to call on hold/incomming call.
R2 Switch between ongoing call and call on hold/incomming call.
R3 This function (normally used for three-party conference) is not
supported in the IP-DECT System.
R4 Transfer call on hold to ongoing call and disconnect.
RR (unattended
transfer)
Put the ongoing call on hold and dial the number to the destination
where the last held call shall be transferred to.
To Next Page
Loading...
Need help?
General
