TD 92579EN
15 February 2012 / Ver. H
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
127
3 Click "Save" in the dialogue window and browse to the place where the
configuration should be saved.
4 Click "Save".
8.15 Software Upgrade
Note: In software version 5.0.x:
The RFP version information is not displayed in the IPBS2 GUI. RFP software is more
integrated now and this information becomes obsolete. In IPBS1 the RFP software has a
separate flash memory, but this is not the case for IPBS2. On the IPBS1 the RFP version is
still displayed.
8.15.1 Before Upgrading
1 For safety, take a backup of the configuration parameters for the Master and
Standby Master.
2 Make a note of the Master and Standby Master IP address.
On the device configured as Master, continue with step 3 to 6 below.
3 When upgrading from software version 2.x.x to later: Select DECT > SMS and make
a note of the IMS3 IP address.
4 When upgrading from software version 2.x.x to later: Select DECT > Master and
make a note of the SIP proxy (registrar) IP address, found in the Gatekeeper IP
Address text field.
5 When upgrading from software version 2.x.x to later: Select DECT > Master and
make a note of the alternative SIP proxy (registrar) IP address, found in the Alt.
Gatekeeper IP Address text field.
8.15.2 Upgrading Sequence
The best order is to start with the firmware and boot file upgrade of the Standby Master,
then the Master, then all Radios, then do the configuration changes. This way the Radios
will not be able to connect to the Master or Standby Master with incompatible firmware.
The upgrading sequence is as follows:
1 Upgrade firmware and boot file of Standby Master, see 8.15.3 IPBS/IPBL Upgrade.
2 Upgrade firmware and boot file of Master, see 8.15.3 IPBS/IPBL Upgrade.
3 Upgrade firmware and boot file of Radios, see 8.15.3 IPBS/IPBL Upgrade.
4 When upgrading from software version 2.x.x to later: Update configuration of
Radios, see
8.15.4 Configuration After Updating the Firmware From Software
Version 2.x.x to Later.
5 When upgrading from software version 2.x.x to later: Update configuration of
Master, see
8.15.4 Configuration After Updating the Firmware From Software
Version 2.x.x to Later.
6 When upgrading from software version 2.x.x to later: Update configuration of
Standby Master, see
8.15.4 Configuration After Updating the Firmware From
Software Version 2.x.x to Later.
7 When upgrading from software version 3.x.x to later: Update configuration of
Master and Standby Master, see
8.15.5 Configuration After Updating the Firmware
From Software Version 3.x.x to Later.
To Next Page
Loading...
Need help?
General
