TD 92579EN
15 February 2012 / Ver. H
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
83
• write connections - Number of write-enabled connections
• rx search - Number of received search requests
• rx modify - Number of received change requests
• rx add - Number of added objects
• rx del - Number of deleted objects
• rx abandon - Number of lost connections
• tx notify - Number of sent change notifications
• tx error - Number of sent error notifications
• tx error 49 - Number of sent error notifications due to invalid credentials
• tx error 50 - Number of sent error notifications due to insufficient access rights
8.4.3 Configure LDAP Replicator
LDAP Replicators are usually configured in the following cases:
• User data is replicated from the Master to the Standby Master. The replicator is
configured on the Standby Master (Full Directory Replication)
• User data is replicated from the Active Directory (AD) to the Master. The replicator is
configured on the Master
• User data is replicated from the PBX to the Master. The replicator is configured on the
Master (Full Directory Replication)
• User data is replicated from the Master to the other Masters in a Multi Master System.
The replicator is configured on the Masters not hosting the LDAP Server. To have full
roaming between Masters, the LDAP user must have write access to the LDAP server.
Configure Full Directory Replication
1 Select LDAP > Replicator.
2 Select "Full Replication" in the Type drop-down list.
3 Select the Enable check box.
4 Enter the IP address to the LDAP server in the Server text field.
5 Enter the IP address to the alternative LDAP server in the Alt. Server text field.
6 NOTE: If this IPBS/IPBL is configured as an alternative/standby LDAP server, leave the
Alt. Server text field empty.Select a filter method from the Filter Type drop-down list
• Dect Gateway Name - Enter the name of the DECT gateway to limit the
replication to users of a certain group
• LDAP Filter - Enter an LDAP filter to limit replication to certain LDAP objects
7 Enter the LDAP User name and Password in the User and Password text fields.
8 Click "OK".
Note: In the case of Master to Standby Master Full Directory Replication, do not register
new handsets when the LDAP Server is down even if there is a Standby LDAP Server in the
system.
Configure Active Directory Replication
During Active Directory (AD) replication the configured LDAP replicator retrieves only
relevant data.
AD replication is a one-way replication where data is only transferred from the AD to the
IP-DECT but not from the IP-DECT to the AD. Data originating from the AD cannot be
To Next Page
Loading...
Need help?
General
