115
Commands
Query commands direct the receiver to output the corresponding response
message once only. Message output prompted by a query command occurs
independently of any related message output settings.
Examples:
Enable the output of the MBN message on port A at five-second intervals
$PASHS,RAW,MBN,A,ON,5
Disable the output of the MBN message on port B
$PASHS,RAW,MBN,B,OFF
Query MBN message and designate port B for output of response message
$PASHQ,MBN,B
As with the other query commands, the port designator (B) is optional. If a port is
not specified, the receiver sends the response to the current port.
G12RevD.book Page 115 Tuesday, April 2, 2002 4:33 PM
To Next Page
Loading...