Page 63
▸ When using Windows Messages
disable other warnings
When controlled via Windows Messages the UP software
does not show any warnings, similarly like in quiet mode
on the commandline.
▸ Pin T during programming
With this setting it is possible to set a logical level during
programming on the T pin. The selected logical level will
be visible on the pin only when the supply voltage is
available at the VDD pin of the programmer.
In case that the T pin is used for programming, this
function will not be available.
This option is available only for FORTE.
▸ Pin T after programming
With this setting it is possible to set a logical level, which
will appear on the T pin after programming. The selected
logical level will be visible on the pin only when the
supply voltage is available at the VDD pin of the
programmer.
In case that the T pin is used for programming, this
function will not be available.
This option is available only for FORTE.
Options ➙ Select programmer
Settings concerning the programmer and the
communication port are described in Programmer
Selection.
Options ➙ Language selection...
Keyboard shortcut: Ctrl+L
A file with a different language localization can be
selected using the Windows standard dialog. This means
that one program installation can easily switch between
different user-interface languages.
Options ➙ Keyboard shortcuts...
Keyboard shortcut: Ctrl+K
Using this dialog window you can define or change
keyboard shortcuts for most commands the programmer
is capable of performing.
This window also provides for setting the required
behavior of the GO button.
Options ➙ Lock project
After a project file has been opened, it is locked against
unintentional changes. To unlock or lock it again this
function can be used.
Help Menu
Help ➙ Help on program
Keyboard shortcut: F1
This command opens the help that you are are just
reading.
Help ➙ List of supported devices
This command displays a list of devices currently
supported by the latest version of UP.
Help ➙ Check Internet for updates
The program connects to the Internet and checks if you
are using the latest version.
Help ➙ ASIX website
This command opens www.asix.cz, the website of ASIX
s.r.o. where you can find the latest drivers and manuals
for ASIX products.
Help ➙ About
Basic information on the program and a contact to
technical support.
To Next Page
Loading...