Page 64
5.5.4 Programmer Settings
Window
All important settings concerning the programmer and
the applications to be programmed are displayed in the
programmer settings window.
The window appearance changes in accordance with the
selected programmer and device.
FORTE Programmer Settings
Window
Power supply from the programmer
This trackbar allows the user to set the voltage level
supplied to the application by the programmer.
In idle state
If this option is checked, the programmer supplies power
to the application even when not programming.
During programming
If this option is checked, voltage from the programmer
will be used during programming.
Reset
This button allows you to switch levels on the device's
reset pin between the level required for reset and high
impedance.
Reset is active if voltage is present on the power supply
pin.
Settings Associated with RX600
Microcontrollers
▸ Protect with ID
If this option is active, it programs also the OSIS(ID) value
during Configuration memory programming, this way it is
possible to lock the device bootloader access.
▸ Allow using Configuration Clearing
(erases TM, ID)
The Configuration Clearing erases a TM (Trusted Memory)
space. When the TM is in use, the use of this option
should be well considered.
The use of this option is the only possibility how to erase
OSIS(ID).
▸ Baud Rate
Using this option it is possible to set a communication
speed between the programmer and the programmed
device.
Settings Associated with PIC
Microcontrollers
▸ Programming method
• HVP Traditional programming will be applied using a
voltage of 8V to 13V at pin P.
• LVP Programming utilizing the microcontroller's LVP
pin will be applied; only logical values of 0 or 1 are
present at programmer's pin P.
▸ Use PE
Programming utilizing the Use PE option can be applied
to PIC24 and dsPIC33 devices. PE stands for Programming
Executive and it is a programming method frequently
proving to be faster. The Programming Executive does
verification after programming, that is why UP does not
verify after PE programming.
Boot memory programming
This allows to select the boot memory region to be
programmed or checked.
To Next Page
Loading...