ASIX Forte - Page 78

Page 78
Question before programming OTP devices
Prog.QBfrDiffProg
boolean
Question before differential programming (of flash
devices)
Prog.QBfrProgCP
boolean
Warning before programming device with some kind of
protection
Prog.CloseStatOnGoodAct
boolean
If true, status window will be automatically closed after
read/verify etc... without errors.
Prog.CloseStatOnGoodProg
boolean
If true, status window will be automatically closed after
programming without errors.
Prog.BeepOnGoodProg
boolean
If true, program makes a sound on successful
programming.
Prog.BeepOnBadProg
boolean
If true, program makes a sound on unsuccessful
programming.
Prog.SoundsOff
boolean
If true, all sounds of the program are switched off.
Prog.SkipBlankForCfg
boolean
If true, no blank check of part is performed before
programming of configuration space.
Prog.SkipBlankCheck
boolean
If true, no blank check of device is performed before
device programming.
Prog.SkipErase
boolean
If true, no erasing is performed before device
programming.
Prog.SkipEraseData
boolean
If true, no erasing is performed before only data memory
programming.
Prog.SkipLastFFVerify
boolean
If true, verification of empty FF positions at the end of the
programmed memory is not preformed.
Prog.SkipVerify
boolean
If true, no verification is performed after programming.
Prog.DoubleVerify
boolean
If true, verification on two supply voltages is performed
after programming. Supported by FORTE with internal
supply voltage only.
Prog.DoubleVerifyV1
integer
Defines supply voltage size for the first verification, the
value is in voltsx10.