ASIX Forte - Page 82

Page 82
SpecSettings.PREST.AVRXTAL.AutoClk
boolean
If true, faster programming with slow clock is used for
AVR MCUs.
SpecSettings.PREST.AVRRSTInverse
boolean
If true, the reset signal polarity is assumed to be inverse
in comparison with standard polarity of the reset signal of
the selected chip. It is supported with AVR and 8051
devices.
SpecSettings.PREST.AVRHVP
boolean
If true, high voltage method is used for AVR MCUs, it is
supported for AVR TPI interface only.
SpecSettings.FORTE.UVCCLevel
integer
Defines the size of the internal supply voltage provided by
FORTE programmer. The value is in voltsx10.
SpecSettings.FORTE.Power
boolean
If true, idle power supply is provided by FORTE
programmer.
SpecSettings.FORTE.ProgPower
boolean
If true, the supply voltage during programming is
provided by FORTE programmer.
SpecSettings.FORTE.LVP
integer
0 HVP method
1 LVP method
SpecSettings.FORTE.UsePE
boolean
If true, PE (programming executive) is used for
programming of PIC MCUs, when programmed by FORTE
programmer.
SpecSettings.FORTE.PIC32MZ_BootProg
integer
0 Lower Boot alias
1 Boot Flash 1 and 2
SpecSettings.FORTE.PSoCAlg
integer
0 automatic selection
1 assume VDD > 3.6V
2 assume VDD =< 3.6V
SpecSettings.FORTE.PSoCRSTInit
integer
0 Reset mode
1 Power cycling
SpecSettings.FORTE.MSP430osc
integer
0 Calibrated internal RC oscilator
1 Not calibrated internal RC oscilator
SpecSettings.FORTE.MSP430speed
integer
0 Normal
1 Slow
2 Slowest