ASIX Forte - Page 83

Page 83
SpecSettings.FORTE.MSP430EraseSegme
ntA
boolean
If true, MSP430 Segment A is erased.
SpecSettings.FORTE.MSP430Interface
integer
0 JTAG
1 SBW
SpecSettings.FORTE.ARMFreq
integer
The value specifies the frequency of connected oscillator
or crystal. This value is used for programming of
ARM7TDMI.
SpecSettings.FORTE.ARMOscType
integer
0 Crystal
1 Ext. Clock
2 Int.RC 32kHz
SpecSettings.FORTE.ARMCommFreq
integer
Selects communication frequency between FORTE
programmer and the programmed chip. The frequencies
are same as stated in the "Communication frequency"
ComboBox in UP. 0 means the highest frequency, 1 is
lower and so on.
SpecSettings.FORTE.SPI_Flash_Freq
integer
Selects communication frequency between FORTE
programmer and the programmed chip. The frequencies
are same as stated in the "Communication frequency"
ComboBox in UP. 0 means the highest frequency, 1 is
lower and so on.
SpecSettings.FORTE.AVRXTAL.DELAY
integer
represents maximum AVR oscillator frequency
value can be found in *.lng files at item
MainForm.PRESTSpecForm.ComboAVRXTALPresto2.xxx.It
ems where xxx is minimum divisor of system clock of
selected AVR's SPI module. This is 2 for new AVRs, 3 and
4 for older AVRs and 24 for Atmel's 8051 arch.
processors.
This setting can be found in ini file too at
[SpecSettings.FORTE], XTALClk.
SpecSettings.FORTE.AVRXTAL.AutoClk
boolean
If true, faster programming with slow clock is used for
AVR MCUs.
SpecSettings.FORTE.AVRRSTInverse
boolean
If true, the reset signal polarity is assumed to be inverse
in comparison with standard polarity of the reset signal of
the selected chip. It is supported with AVR and 8051
devices.
SpecSettings.FORTE.AVRHVP
boolean
If true, high voltage method is used for AVR MCUs, it is
supported for AVR TPI interface only.
SpecSettings.FORTE.ATxmegaInterface
integer
0 PDI
1 JTAG
SpecSettings.FORTE.i2cSpeed