ATEQ F580 - Page 128

Chapter 4 – Functions of the instrument
UM-18400E-U ATEQ F580 User manual Page 118/168
2.2.4. Regulator control
The REGULATOR CONTROL function appears when an electronic regulator is
installed in the instrument.
If there is no air pressure supply, the instrument will display a
REGULATOR ERROR.
When the instrument is configured on
EXTERNAL, the instrument awaits a press on the
RESET key to resume operation.
When the instrument is configured on
AUTO it constantly attempts to resume operation.
A prolonged operation of the regulator in this mode and without compressed air could
cause a heating up and premature ware on the element.
2.2.5. Piezo auto zero
This function enables the setting of the frequency or of the number of measurement
cycles between two Piezo auto zeros.
¾ Number of minutes: to set a time space between two auto zeros of 1 to 999
minutes. When the dial is on zero, no auto-zero is carried out.
¾ Number of cycles: to set a gap of a certain number of cycles between two auto
zeros is carried out.
Confirm with
Yes the PIEZO AUTO AZ
in the
Configuration menu.
Then, enter the frequency parameter
and/or number of cycles.
CONFIG
LANGUAGE : English
AUTO SAVE : YES
PIEZO AUTO ZERO : YES
FREQUENCY : 00
NB CYCLES : 00
ELECTRONIC REGUL. : without
RS232 : C540/580
FIELD BUS
SECURITY : NO
1
3
:
31
:
1
1
21
/
0
3
/
200
5
Note: the two options can be set, in this case the first counter to expire will launch the
auto-zero, both counters will then be reset.
) Select the option and enter settings if necessary.