Chapter 3 – Start-up and settings
UM-18400E-U ATEQ F580 User manual Page 54/168
7.3. CHOICE OF THE MEASUREMENT UNIT PROGRAM
To choose the program to be carried out by a measurement unit (head), it is necessary
to previously select it, to do this, follow the procedure presented below:
Select the "RUN" menu and confirm
with the "ENTER" key.
MAIN MENU
RUN CONFIG
PARAMETERS SERVICE
DISPLAY RESULTS
16:45:32 11/07/2002
Select the unit in which the cycle
number choice must be made and
confirm.
RUN
CENTRAL
HEAD 1 : F5 :
HEAD 2 : F5 :
START KEY
Place the cursor in front of the "ACTIVE
PROG" menu and confirm.
RUN
RUN PROGRAMME : Pr01 LEAK TEST
SPECIAL CYCLE : Disabled
In the menu, select the program to be
activated (only programs created are
displayed), then confirm.
Pr:01 LEAK TEST
Pr:02 LEAK TEST
Pr:03 LEAK TEST
Pr:04 OPERATOR
The instrument confirms the program
number selected, it is now possible to
start the cycle (in this unit only) by using
the key.
RUN
RUN PROGRAMME : Pr02 LEAK TEST
SPECIAL CYCLE : Disabled
Return to the main menu by pressing
several times on the
C
key.
Note: it is possible to start all the measurement units at the same time by pressing on
the start key in a previous menu.
To Next Page
Loading...