Chapter 3 – Start-up and settings
UM-18400E-U ATEQ F580 User manual Page 53/168
7. LAUNCHING A CYCLE
7.1. START KEY
It is possible to start a test cycle on one, several or all the measurement units (heads). It
is actually possible to allocate one or more units to the START key. For that, just select
the units which are required to start a cycle with "YES" in the "RUN/START KEY" menu.
In the "RUN" menu, select the "START
KEY" menu; confirm with a "YES" the
measurement units for which we want to
start a test program.
RUN
CENTRAL
HEAD 01 : F5 :
HEAD 02 : F5 :
START KEY
HEAD 01 : YES
HEAD 02 : YES
Press on the START key to launch the
measurement cycle.
Depending on the display mode chosen, the
cycle stages and the results are presented
differently.
Refer to chapter 4, paragraph 1.4 "display
menu".
7.2. DISPLAY OF THE MEASUREMENTS
Before starting the measurements, select a display type:
To do this, in the main menu, select the
"DISPLAY MENU".
MAIN MENU
RUN CONFIG
PARAMETERS SERVICE
DISPLAY RESULTS
In the "DISPLAY MENU" select the
"STANDARD" menu, then validate with
a "YES".
Next, confirm with a "YES" the unit(s)
displayed on the screen.
DISPLAY
CENTRAL
STANDARD : YES
HEAD 1 : YES
HEAD 2 : YES
COMPACT : NO
RESULTS : NO
CURVE : YES
LED DISPLAY : NO
09:19:36 21/08/2002
To Next Page
Loading...