Chapter 3 – Start-up and settings
UM-18400E-U ATEQ F580 User manual Page 39/168
3.2. ALLOCATION OF THE MODULES
3.2.1. "Extended" mode
The extended mode configuration function enables modifications to be made allowing
the transfer of a measurement unit from one I/O module to another. Example with two
I/O modules and two measurement units (heads):
Confirm the "I/O DISTRIBUTION"
function. A list of measurement units
(heads) and their allocation to the
modules appears, confirm, the icon
changes into an “up/down arrow”.
CONFIG
MODULE 1 : HEAD 01
MODULE 2 : HEAD 02
Using the up and down keys, choose
the affectation of the unit on the
module required, confirm when the
selection is finished.
CONFIG
MODULE 1 : HEAD 02
MODULE 2 : HEAD 01
3.2.2. "Standard" mode
In standard mode configuration, this function enables the modification of the allocation
of a measurement unit on a block of an I/O module to transfer it to another.
Confirm the "I/O DISTRIBUTION"
function. A list of measurement units
(heads) and their allocation to the
modules appears, confirm, the icon
changes into an “up/down arrow”.
CONFIG
MODULE 1 BLOCK 1 : HEAD 01
MODULE 1 BLOCK 2 : HEAD 02
MODULE 1 BLOCK 3 : HEAD 03
Using the up and down keys, choose
the affectation of the unit on the
module required, confirm when the
selection is made.
CONFIG
MODULE 1 BLOCK 1 : HEAD 02
MODULE 1 BLOCK 2 : HEAD 01
MODULE 1 BLOCK 3 : HEAD 03
3.2.3. "Compact" mode
In compact mode configuration, this function enables the modification of the allocation
of a measurement unit on a block of an I/O module to transfer it to another.
Confirm the "I/O DISTRIBUTION"
function. A list of measurement units
(heads) and their allocation to the
modules appears, confirm, the icon
changes into an “up/down arrow”.
CONFIG
MODULE 1 OUTPUTS 1 : HEAD 01
MODULE 1 OUTPUTS 2 : HEAD 02
MODULE 1 OUTPUTS 3 : HEAD 03
To Next Page
Loading...
