ATEQ F580 - DC Power Supplies

Chapter 5 - Accessories
UM-18400E-U ATEQ F580 User manual Page 150/168
2.5. 24 V DC POWER SUPPLIES
This power supplies allows the functioning of the network with 24 V DC.
Two models are available:
2.5.1. 4 A power supply
The 4 Amp version is destined to power a
network with three measurement units (heads)
maximum.
It can be fixed to a bench or DIN rail.
Consult the power supply instructions before
any installation.
Note: install the power supply in such a way
as to encourage heat dissipation.
50
93
145
2.5.2. Connection diagram
1 2 3 4 5
Pin 1 + 24 V DC Pin 4 Phase 220 V AC
Pin 2 0 V DC Pin 5 Neutral 220 V AC
Pin 3 Earth
2.5.3. 14 A power supply
The 14 Amp version is destined to power a
network with 9 measurement units (heads) and
three I/O modules.
It can be fixed to a bench or DIN rail.
Consult the power supply instructions before
any installation.
Note: install the power supply in such a way as
to encourage heat dissipation.
92
1
2
3
4
185
5
6
7
110
2.5.4. Connection diagram
1
2
3
4
5
6
7
Pin 1 and 2 + 24 V DC Pin 6 Neutral 220 V AC
Pin 3 and 4 0 V DC Pin 7 Earth
Pin 5 Phase 220 V AC