Chapter 3 – Start-up and settings
UM-18400E-U ATEQ F580 User manual Page 60/168
9.3. SETTING A FILLING INSTRUCTION WITH AN ELECTRONIC REGULATOR
9.3.1. Pressure adjust
When instrument is fitted with an electronic regulator, the test pressure value is that
shown since this is the fill target. No special cycle is required..
To enter a fill target see the previous section.
Note: the input pressure for an instrument with electronic regulator must be at least 100
kPa (1 bar) greater than test pressure.
10. STOPPING A CYCLE
Press the RESET key to stop
the measurement in progress.
The instrument is stopping his
cycle and configured for a new
measurement test.
To Next Page
Loading...