ATEQ F580 - 8. Launch of a Special Cycle

Chapter 3 – Start-up and settings
UM-18400E-U ATEQ F580 User manual Page 55/168
8. LAUNCH OF A SPECIAL CYCLE
To start a special cycle on a measurement unit follow the procedure below. Example for
the adjustment of a regulator:
Select the "RUN" menu and confirm
with the "ENTER" key.
MAIN MENU
RUN CONFIG
PARAMETERS SERVICE
DISPALY RESULTS
16:45:32 11/07/2002
Select the measurement unit (head)
with which the special cycle must be
started then confirm.
RUN
CENTRAL
HEAD 1 : F5 :
HEAD 2 : F5 :
START KEY
16:54:35 11/07/2002
Place the cursor in front of the
"SPECIAL CYCLE" menu and confirm.
RUN
RUN PROGRAMME : Pr01 LEAK TEST
SPECIAL CYCLE : Disabled
17:41:07 11/07/2002
All the special cycles available are
displayed, place the cursor in front of
the special cycle required (here,
"Regulator adjust. 1") and confirm.
RUN
RUN PROGRAMME : Pr01 LEAK TEST
SPECIAL CYCLE : Disabled
17:41:07 11/07/2002
Disabled
Regulator adjust 1
Regulator adjust 2
Infinite fill
Piezo auto zero