ATEQ F580 - 2.4. PS5 Junction Box Module

Chapter 5 - Accessories
UM-18400E-U ATEQ F580 User manual Page 149/168
2.4. PS5 JUNCTION BOX MODULE
2.4.1. Presentation of the module
The PS5 junction box module is an accessory
to be used in a network built with several
measurement units (heads) piloted by a
central unit.
The network requiring an architecture of
elements connected in series, this module
cancels out the over intensity in the first
electrical elements (cables and connectors)
used for the network link.
The module can supply power to one C545
central module and four measurement units.
The case is equipped to be fixed to a DIN rail.
To the right is a diagram of the case:
24 V CE
MODULE PS5 N.
www.ateq.com
MADE BY ATEQ
J3
RS485
IN
J9
RS485
OUT
J1
24 V ===
3A max.
POWER INPUT
24V ===
15 A max
J5 J7
J4 J2 J6 J8
2.4.2. Input connectors J1 J3 J5 J7 (RS485)
2 1
4
3
Reserved for ATEQ network.
For connection to other ATEQ instruments.
(Lumberg type male connector).
Pin 1 Network (D+) Pin 3 Network (D-)
Pin 2 Tension + 24 V Pin 4 Masse 0V
2.4.3. Output connectors J2 J4 J6 J8 (RS485)
2
1
4
3
Reserved for ATEQ network.
For connection to the remote heads. 2 metre, 5 metre or 10
metre cables are supplied depending on the configuration of
the installation. (Lumberg type female connector).
Pin 1 Network (D+) Pin 3 Network (D-)
Pin 2 Tension + 24 V Pin 4 Masse 0V
2.4.4. J9 connector (24 V DC power supply)
2
1
3
Allows the 24 V DC power supply for the module and the
network. (Jaeger type connector).
Pin 1 Not used Pin 3 0V
Pin 2 +24V DC Voltage