ATEQ F580 - 4. Management of the Measurement Units

Chapter 3 – Start-up and settings
UM-18400E-U ATEQ F580 User manual Page 40/168
4. MANAGEMENT OF THE MEASUREMENT UNITS
The icon is displayed after confirmations. It indicates that the central module
communicates with the instruments in the network.
4.1. MEASUREMENT UNIT (HEAD) CONFIGURATION
The setting of parameters for a measurement unit on the keyboard of the C540 central
is done identically to the setting of the parameters on the front panel of the
measurement unit itself, after it has been selected. Example for the setting of a
measurement unit’s parameters:
From the main menu, select the
"PARAMETERS" menu and confirm
with the "ENTER" key.
MAIN MENU
RUN CONFIG
PARAMETERS SERVICE
DISPLAY RESULTS
10
:
48
:
13
24
/0
7
/2002
By using the cursor, select the
measurement unit in which the
parameters are going to be modified
and confirm with the "ENTER" key.
PARAMETERS
CENTRAL
COPY : HEAD 00 : ---
PASTE : HEAD 00 : ---
HEAD 01 :F5 :
HEAD 02 :F5 :
10
:
4
9
:
3
2
24
/0
7
/2002
The test programs of the measurement
unit are displayed, next, select the
program to be modified and confirm
with the "ENTER" key.
PARAMETERS
CENTRAL
COPY : HEAD 00 : ---
PASTE : HEAD 00 : ---
HEAD 01 :F5 :
HEAD 02 :F5 :
1
1
:
03
:2
5
24
/0
7
/2002
Pr:01 LEAK TEST
Pr:02 LEAK TEST
Pr:03 BLOCKAGE
Pr:04 D MODE
Pr:05 OPERATOR
Pr:06 ----------
Pr:07 ----------
P
r:
08
-
---------