ATEQ F580 - Page 51

Chapter 3 – Start-up and settings
UM-18400E-U ATEQ F580 User manual Page 41/168
Next, access the parameters, the
functions, or carry out a copy-paste of
the parameters from one program to
another.
PARAMETERS
PARAMETERS
FUNCTIONS
Copy-Paste
1
1
:
10
:
01
24
/0
7
/2002
For the programming of the test
parameters, refer to the measurement
unit user manual.
To the right is an example of a
parameters window of a leak detection
unit.
PARAMETERS
TYPE : LEAK TEST
COUPLING A : 00.0 s
FILL : 01.0 s
STABILISATION : 00.5 s
TEST : 01.0 s
DUMP : 00.5 s
PRESSURE UNIT : bar
Max. FILL : 10.0 bar
Min. FILL : 0.000 bar
15:28:34 20/08/2002
To the right is an example of a functions
window of a leak detection
measurement unit.
The functions must be activated in
the "CONFIGURATION" menu to
appear in the "FUNCTIONS" menu.
PARAMETERS
NAME : CYLINDER HEAD
CYCLING : NO
TRANSIENT ABSORB. 0 : NO
TRANSIENT ABSORB. 1 : NO
TRANSIENT ABSORB. 2 : NO
PRE-FILL : NO
FILL MODE : NO
VALVES CODES : NO
END CYCLE : NO
15:39:59 20/08/2002