ATEQ F580 - 4.2. Creation of a Test Program

Chapter 3 – Start-up and settings
UM-18400E-U ATEQ F580 User manual Page 42/168
4.2. CREATION OF A TEST PROGRAM
To create a test program for a measurement unit on the C540 central unit keyboard
follow the procedure below.
Setting the parameters for a measurement unit:
From the main menu, select the
"PARAMETERS" menu and confirm
with the "ENTER" key.
MAIN MENU
RUN CONFIG
PARAMETERS SERVICE
DISPLAY RESULTS
10
:
4
8
:
23
24
/0
7
/2002
Using the cursor, select the
measurement unit in which the
parameters will be modified and confirm
with the "ENTER" key.
PARAMETERS
CENTRAL
COPY : HEAD 00 : ---
PASTE : HEAD 00 : ---
HEAD 01 :F5 :
HEAD 02 :F5 :
10
:
4
9
:
3
2
24
/0
7
/2002
The measurement unit test programs
which have already been created are
displayed. Next, select an empty
program to be created (usually "--------")
and confirm with the "ENTER" key.
PARAMETERS
CENTRAL
COPY : HEAD 00 : ---
PASTE : HEAD 00 : ---
HEAD 01 :F5 :
HEAD 02 :F5 :
1
1
:
03
:2
5
24
/0
7
/2002
Pr:01 LEAK TEST
Pr:02 LEAK TEST
Pr:03 LEAK TEST
Pr:04 OPERATOR
Pr:05 ----------
Pr:06 ----------
Pr:07 ----------
P
r:
08
-
---------
Next, access the parameters, the
functions or carry out a copy-paste
operation to another program.
PARAMETERS
PARAMETERS
FUNCTIONS
Copy-Paste
1
1
:
10
:
01
24
/0
7
/2002