ATEQ F580 - Page 53

Chapter 3 – Start-up and settings
UM-18400E-U ATEQ F580 User manual Page 43/168
For the programming of the test
parameters please refer to the manual
concerning the measurement unit.
To the right is an example of a leak
detection unit parameters window.
PARAMETERS
TYPE : LEAK TEST
COUPLING A : 00.0 s
FILL : 01.0 s
STABILISATION : 00.5 s
TEST : 01.0 s
DUMP : 00.5 s
PRESSURE UNIT : bar
Max. FILL : 10.0 bar
Min. FILL : 0.000 bar
15:28:34 20/08/2002
To the right is an example of a leak
detection unit functions window.
The functions must be activated in
the "CONFIGURATION" menu to
appear in the "FUNCTION" menu.
PARAMETERS
NOM : CYLINDER HEAD
CYCLING : NO
TRANSIENT ABSORB. 0 : NO
TRANSIENT ABSORB. 1 : NO
TRANSIENT ABSORB. 2 : NO
PRE-FILL : NO
FILL MODE : NO
VALVES CODES : NO
END CYCLE : NO
15:39:59 20/08/2002
Note: when a parameter is modified, it is possible to move the
comer to unit, ten, hundred, etc. by using the left and right
arrows.