ATEQ F580 - Instruction Adjustment with Mechanical Regulator

Chapter 3 – Start-up and settings
UM-18400E-U ATEQ F580 User manual Page 58/168
9.2. INSTRUCTION ADJUSTMENT WITH MECHANICAL REGULATOR
To access the filling instruction function, it must first be activated in the expanded
menus before the test program is created.
Refer to chapter 4 § 2.2.1 "EXTENDED MENUS"
and § 2.2.1.1) "Activation of additional functions".
Then refer to § 2.2.1.3) j) "Fill mode".
If the instrument is fitted with two regulators
also refer to § 2.2.1.3) l) "Fill regulator"
to identify which of the two regulators is the fill regulator.
Validate the special function in the
"EXTENDED MENUS" menu of the
heads configuration.
CONFIG
NAME : NO
CYCLING : NO
AUTO CONNECTOR : NO
ETAL CHECK : NO
TRANSIENT ABSORB. 0 : NO
TRANSIENT ABSORB. 1 : NO
TRANSIENT ABSORB. 2 : NO
P.FILL MODE : NO
FILL MODE : YES
10:48:26 24/07/2002
In the "PARAMETERS" menu, select
the head and validate with the "ENTER"
key
.
PARAMETERS
CENTRAL
COPY : HEAD 00 : ---
PASTE : HEAD 00 : ---
HEAD 01 :F5 :
HEAD 02 :F5 :
10
:
4
9
:
3
2
24
/0
7
/2002
Select the test program
and validate with the "ENTER" key.
PARAMETERS
CENTRAL
COPY : HEAD 00 : ---
PASTE : HEAD 00 : ---
HEAD 01 :F5 :
HEAD 02 :F5 :
1
1
:
03
:2
5
24
/0
7
/2002
Pr:01 LEAK TEST
Pr:02 LEAK TEST
Pr:03 LEAK TEST
Pr:04 OPERATOR
Pr:05 ----------
Pr:06 ----------
Pr:07 ----------
P
r:
08
-
---------