ATEQ F580 - Page 66

Chapter 3 – Start-up and settings
UM-18400E-U ATEQ F580 User manual Page 56/168
The instrument confirms the selection of
the special cycle "Regulator adjust. 1",
it is now possible to start the cycle (in
this unit only) by using the key.
RUN
RUN PROGRAMME : Pr01 LEAK TEST
SPECIAL CYCLE : Regulator 1
17:41:07 11/07/2002
It is possible to make several
measurement units carry out different
special cycles. To do so, just select the
units one after the other and confirm the
special cycles that are required on each
given unit.
RUN
CENTRAL
HEAD 1 : F5 :
HEAD 2 : F5 :
START KEY
16:41:57 11/07/2002
After having selected all the special
cycles, return to the main menu, then
launch all the special cycles at once.
RUN
RUN PROGRAMME : Pr01 LEAK TEST
SPECIAL CYCLE : Infinte Fill
17:42:18 11/07/2002
Adjust the pressure(s) with the regulator
handle(s).
_
+
Press on the RESET key to stop the
special cycle in progress. The
instrument(s) stop the cycle and
prepare for a new measurement cycle.
ATEQ C540
---- H01 ----
RUN/Pr:001
PRESS = 1.50 bar
LEAK = 059 Pa
READY (OK)
---- H02 ----
RUN/Pr:001
PRESS = 2.00 bar
LEAK = 008 Pa
READY (OK)