Chapter 4 – Functions of the instrument
UM-18400E-U ATEQ F580 User manual Page 124/168
2.2.13. I/O configuration
2.2.13. 1) Input 7 (IN7)
This menu is used to configure programmable input 7 on connector J3 on the 16-
program input/output board.
Refer to Chapter 1, paragraph 4.3.12.2) "Connector J3 (binary Inputs/Outputs)
programmable input".
The various functions which can be set on input 7 are: "Program selection", "Pressure 1
Regulator 1 check test", "Pressure 1 Regulator 2 check test", "Pressure 2 Sensor
check", "Leak sensor check", "Valve Auto-test", "Sensor status", "Regulator 1 adjust",
"Regulator 2 adjust", "Infinite fill", "Part regulator", “Piezo auto zero”, "ATR learning
cycle", "Volume compute", "Sealed Pass part learn", "Sealed Fail part learn”, "Check
test result".
These functions represent all the special cycles available.
2.2.13. 2) Output
Two output modes are available: STANDARD mode and COMPACT mode.
They enable the configuration of the outputs available in two different ways.
For the wiring of the outputs, please refer to chapter 1 paragraph 4.3.12.2) "Relay board
16 programs".
The compact mode enables the output of test results for two sequenced cycles
maximum. Outputs 1 and 2 are reserved to the first cycle, outputs 3 and 4 to the
second, output 5 for the general cycle end.
To Next Page
Loading...