Chapter 4 Functions of the instrument
UM-18400E-U ATEQ F580 User manual Page 126/168
Special cycle Function
9 Volume calculation:
Cycle used to calculate the volume of the test
circuit.
To run a special cycle, select it in the "special cycles" menu, then press the
button. To stop it, press the button. In some cycles the stop is automatic.
Note: to start the special cycle on one or more measurement units (heads), refer to
chapter 3 paragraph 7 "Launching a cycle".
Note: it is possible that after selecting a special cycle, it is necessary to enter one or
more parameters. The special cycle is validated once the(se) parameter(s) have been
set. This is valid for one measurement unit or more.
The starting of the special cycle is only done in the measurement unit selected,
otherwise the start will concern al the measurement units by pressing on the
C
key
before the starting of the cycle.
To Next Page
Loading...