ATEQ F580 - Page 47

Chapter 3 – Start-up and settings
UM-18400E-U ATEQ F580 User manual Page 37/168
In the "Head (measurement unit)"
menu it is necessary to indicate the
quantity of measurement units which
are installed in the network.
In the "I/O Module" parameter it is
necessary to indicate the quantity of
input/output modules which are
installed in the network.
CONFIG
CENTRAL
NETWORK
INSTALL
HEAD : 02
I/O MODULES : 01
IDENTIFICATION
I/O MODE : EXTENDED
I/O DISTRIBUTION
LANGUAGE : ENGLISH
11:02:59 18/06/2002
By using the navigation keys, bring the
cursor in front of the
"IDENTIFICATION" menu and confirm.
CONFIG
CENTRAL
NETWORK
INSTALL
HEAD : 02
I/O MODULES : 01
IDENTIFICATION
I/O MODE : EXTENDED
I/O DISTRIBUTION
LANGUAGE : ENGLISH
11:06:45 18/06/2002
Each measurement unit (head) awaits
the validation of the numbering order.
Each instrument head must be
activated in the required order by using
the button on its back-panel.
IDENTIF
H01 H02 H03
??? ??? INT
The internal relay board is detected
and automatically validated; the
information appears on the screen
with the type of unit.
IDENTIF
H01 H02 H03
F5 ??? INT
Once all the measurement units are
identified, press on the ENTER key to
validate the installation.
IDENTIF
H01 H02 H03
F5 F5 INT
Once the measurement units are
validated, the instrument returns to the
"CONFIGURATION" menu. Return to
the main menu to carry out test cycles.
CONFIG
CENTRAL
NETWORK
INSTALL
HEAD : 02
I/O MODULES : 01
IDENTIFICATION
I/O MODE : EXTENDED
I/O DISTRIBUTION
LANGUAGE : ENGLISH
11:08:13 18/06/2002