FlexiROC T35 R/T40 R 10 Options
124 No: 3171473547.1 en
Brushes for thread lubrication.
Operation
Lubrication is regulated with a switch that is described in the chapter, Controls.
n During normal use, the system will operate automatically. The grease pump will then
operate when the rod handling lever is in position to move a rod to the drill centre. This
means that each time a rod is moved out from the carousel, a certain amount of
grease will be pumped to the brushes that the rod threads subsequently pass.
n If it is necessary to pump more grease to the brushes, the system can be operated
manually. The grease pump will then be active as long as the circuit breaker for greas-
ing is held in MANUAL position.
n If thread lubrication is not desired, the system can be switched off.
To Next Page
Loading...
Need help?
General
