FlexiROC T35 R/T40 R 5 Controls
70 No: 3171473547.1 en
The shape of the pulse is adjusted on the bottom
knob. It must always be at B.
!
NOTE: The entire system can
be turned off by stopping the
supply of air with the cock by
the grease pump.
5.2.2 Test connections for the hydraulic circuits
Test instrument for checking the hydraulic circuits.
Connect the test instrument to the different outlets (see table below).
1 Hydraulic pump 1: Percussion, Drill feed, Rapid
feed, Tramming
2 Hydraulic pump 2: Rotation, Preheating
3 Hydraulic pump 3: Winch and positioning/DCT
4 Hydraulic pump 4: Radiator
5 Hydraulic pump 5: Not used
6 Drill extractor pressure *
7 Pilot pressure
8 Not used
!
NOTE: * Extra equipment
To Next Page
Loading...
Need help?
General
