Atlas Copco FlexiROC T35 R User Manual

FlexiROC T35 R/T40 R 4 Daily checks
31 No: 3171473547.1 en
Check point Inspection Instructions
the needle is in the red zone,
the filter must be changed.
Call for a service technician.
Check all the pressure gauges
to see that the hydraulic pres-
sure is normal. Call for a service
technician if there are any devi-
ations.
Table11: Checks during drilling
For further instructions, see: Maintenance instructions
4.5.2 Diesel control panel
Check point Inspection Instructions
Diesel control panel Visual check Check that no fault indicator
lamp is on. In the event of a fault
indication, stop the rig and rec-
tify the fault.
Table12: Diesel control panel.
4.5.3 Dust collector (DCT)
Check point Inspection Instructions
Dust collector (DCT) Suction ability and filter cleaning In case of dust formation: Check
the filter in the filter holder and
suction hose and also the drill-
steel support's drill gasket.
Table13: Dust collector (DCT).
4.5.4 Drill rig
Check point Inspection Instructions
Drill rig Visual check Look for any signs of leaks.
-Hydraulic systems
-Fuel system
-Cooling system
-Compressor
Table14: Drill rig.

Atlas Copco FlexiROC T35 R Specifications

General

Brand	Atlas Copco
Model	FlexiROC T35 R
Category	Construction Equipment
Language	English