FlexiROC T35 R/T40 R 7 Before drilling
97 No: 3171473547.1 en
Incorrect set up.
6.
Position the feed beam to desired inclination and place the spike firmly against the
ground without lifting the drill rig. Right and left-hand multifunction lever.
!
NOTE: Do not lift the drill rig with the feeder!
7.4 Setup for drilling - General principles
7.4.1 Setting-up in general, summary
Set up the drill rig as close to the horizontal as possible with track oscillation in open posi-
tion .
Lower the jack steadily against the ground without lifting the track frames from the ground.
Secure the track oscillation lock and then start positioning the boom and feeder.
Set the feeder jack steadily against the ground without lifting the track frames from the
ground.
!
NOTE: Position the boom and feeder with smooth movements.
!
NOTE: Never unlock the track oscillation lock while the drill rig is set up for drilling
General setup.
To Next Page
Loading...
