FlexiROC T35 R/T40 R 10 Options
131 No: 3171473547.1 en
Setting
WARNING
Serious injury
Never carry out maintenance work while the drill rig is in operation
u Make sure that the hydraulic, water and air systems are depressurised and that the
electrical system is without current before starting any work
The system has two possible settings:
n Basic setting with shut-off valve (5). To set the amount of water when the system is run
in MANUAL, the shut-off valve can be closed slightly.
n Setting water mist. In AUTO, the amount of water can be set with the needle valve (7).
Note that there is a certain delay after activating the water mist before the water emerges
from the drill bit.
To Next Page
Loading...
