FlexiROC T35 R/T40 R 7 Before drilling
94 No: 3171473547.1 en
Remote control box.
2.
Position the feed beam horizontally. Right and left multifunction levers.
3.
Put the remote-control box in drilling mode. Knob S130, position (b).
4.
Move the rod handling arms into the carousel. Left-hand multifunction lever, position
(a).
5.
Rotate the rod carousel anticlockwise to its end position. Left-hand multifunction lever,
position (e).
6.
Activate the rapid feed stop to contain the correct stops with the rock drill. Switch
S113, position (c).
7.
Run the rock drill down to its lowest position. Right-hand multifunction lever, position
(a).
8.
Open the upper and lower drill-steel supports. Switches S187 and S119, position (c).
9.
Insert the first drill steel through the drill-steel supports (use suitable lifting equipment
to lift the drill steel) and then close them. Switches S187 and S119, position (a).
Close the drill-steel support to hold the drill rod.
10.
Screw the adapter fully into the drill steel sleeve. Right-hand multifunction lever, posi-
tion (g).
Screw the drill steel onto the adapter.
To Next Page
Loading...
Need help?
General
