Need help?Do you have a question about the Audio Precision SYS-2722 and is the answer not in the manual?
General| Type | Audio Analyzer |
|---|---|
| Channels | 2 |
| Signal-to-Noise Ratio (SNR) | >120 dB |
| Supported Sample Rates | 32 kHz to 192 kHz |
| Dynamic Range | >120 dB |
| THD+N | 0.0005% |
| Input Impedance | 10 kΩ |
| Digital Interface | AES/EBU, S/PDIF, TOSLINK |
| Bit Depth | 24-bit |
| Interface | USB |
| Audio Analyzer Type | Dual-channel |
Provides an overview of the 2700 series instrument capabilities.
Details the process of installing the AP2700 control software on a PC.
Details hardware setup procedures including power and fuse configuration.
Details connecting the instrument to the mains power supply.
Guides on connecting the instrument to a PC using various interface options.
Guides on using the analog analyzer for measurements.
Details how to control waveform, frequency, and amplitude.
Introduces sweeps for device testing and data gathering.
Explains the basic setup and operation of sweeps.
Demonstrates how to perform a frequency response sweep.
Demonstrates how to perform an amplitude linearity sweep.
Introduces digital signal processing analysis tools.
Explains the FFT spectrum analyzer tool.
Guides on setting up the FFT spectrum analyzer.
Guides on saving and loading test configurations.
Details the specifications for analog signal outputs.
Details the specifications for the analog analyzer.
Details specifications for DSP analysis of analog signals.
Details the specifications for the digital signal generator.
Details the specifications for the digital analyzer.
Describes auxiliary signals available on the front panel.
Describes auxiliary signals available on the rear panel.
Outlines a process for developing GPIB software.
Discusses using both GPIB and APIB for software development.
Guides on establishing GPIB communication.
Details the physical connection for GPIB.
Explains how to set the GPIB address and control mode.
To Next Page
