AudioCodes Mediant 4000 SBC - Page 820

CHAPTER51 Reporting Information to External Party
Mediant 4000 SBC | User's Manual
Field Description
■ The field is applicable only to SBC media and Gateway CDRs.
■ The default field title is "RtpIp" for Syslog Signaling and Local Storage,
"RemoteRtpIp" for Syslog Media, and "h323-remote-address=" for
RADIUS.
■ The maximum number of characters for Syslog tabular alignment is 20.
Remote
RTP Port
[623]
Displays the remote RTP port. This field is an integer from 0 to 0xFFFF.
Note:
■ The field is included in the default CDR.
■ The field is applicable only to "CALL_END", "CALL_CONNECT",
"MEDIA_START", "MEDIA_UPDATE", and "MEDIA_END" CDR Report
Types.
■ The field is applicable only to SBC media and Gateway CDRs.
■ The default field title is ""Port" for Syslog Signaling and "RemoteRtpPort"
for Syslog Media.
■ The maximum number of characters for Syslog tabular alignment is 5.
Remote SIP
User Agent
[818]
Displays the remote SIP User-Agent header value.
Note:
■ The field is optional and can be included in the CDR using the SBC CDR
Format table.
■ The field is applicable only to "CALL_START", "CALL_CONNECT", and
"CALL_END" CDR Report Types.
■ The field is applicable only to SBC signaling.
■ The maximum number of characters for Syslog tabular alignment is 41.
Remote
SSRC
Sender
[619]
Displays the remote (sender) RTP synchronization source (SSRC). The field is
an integer from 0 to 0XFFFFFFFF.
Note:
■ The field is included in the default CDR.
■ The field is applicable only to "CALL_END" and "MEDIA_END" CDR
Report Types.
■ The field is applicable only to SBC media and Gateway CDRs.
■ The default field title is "RemoteRTPssrc" for Gateway Syslog and
"RxRTPssrc" for SBC Syslog Media.
■ The maximum number of characters for Syslog tabular alignment is 14.
Report Type
[303]
Displays the type of CDR report. The field is a string:
■ "CALL_START": The CDR is sent upon an INVITE message.
■ "CALL_CONNECT": The CDR is sent upon a 200 OK response.
■ "CALL_END": The CDR is sent upon a BYE message.
■ "DIALOG_START": The CDR is sent upon the start of a non-INVITE
session (only when enabled, using the EnableNonCallCdr parameter).
■ "DIALOG_END": The CDR is sent upon the end of a non-INVITE session
(only when enabled, using the EnableNonCallCdr parameter).
- 787 -