AudioCodes Mediant 4000 SBC - Page 821

CHAPTER51 Reporting Information to External Party
Mediant 4000 SBC | User's Manual
Field Description
■ "DIALOG_CONNECT ": The CDR is sent upon establishment of a non-
INVITE session (only when enabled, using the EnableNonCallCdr
parameter).
■ "MEDIA_START": The CDR is sent upon 200 OK response or early media
■ "MEDIA_UPDATE": The CDR is sent upon a re-INVITE message
■ "MEDIA_END": The CDR sent is upon a BYE message
Note:
■ The field is included in the default CDR.
■ The field is applicable to all CDR Report Types.
■ The field is applicable to SBC media and signaling, and Gateway CDRs.
■ The default field title is "GWReportType" for Gateway Syslog and Local
Storage, "SBCReportType" for SBC Syslog and Local Storage, and
"MediaReportType" for SBC Syslog Media.
■ The maximum number of characters for Syslog tabular alignment is 15.
RTP IP
DiffServ
[624]
The field displays the RTP IP DiffServ. The valid value is an integer from 0 to
63.
Note:
■ The field is included in the default CDR.
■ The field is applicable to "CALL_END", "CALL_CONNECT", "MEDIA_
START", "MEDIA_UPDATE", "MEDIA_END" CDR Report Types.
■ The field is applicable only to SBC media and Gateway CDRs.
■ The default field title is "TxRTPIPDiffServ".
■ The maximum number of characters for Syslog tabular alignment is 15.
Session ID
[302]
Displays the unique session ID. The field value is a string of up to 24
characters.
Note:
■ The field is included in the default CDR.
■ The field is applicable to all CDR Report Types.
■ The field is applicable to SBC media and signaling, and Gateway CDRs.
■ The default field title is "SessionId".
■ The maximum number of characters for Syslog tabular alignment is 24.
Setup Time
[411]
Displays the date and time that the call was setup. The field value is a string of
up to 35 characters and presented in the following format:
<hh:mm:ss:ms> UTC <DDD> <MMM> <DD> <YYYY>. For example,
"17:00:49.052 UTC Thu Dec 14 2017"
Note:
■ To configure the time zone string (e.g., "UTC" - default, "GMT+1", and
"EST"), use the TimeZoneFormat parameter.
■ The field is included in the default CDR.
■ The field is applicable to all CDR Report Types.
■ The field is applicable only to SBC signaling and Gateway CDRs.
■ The default field title is "SetupTime"" for Syslog and Local Storage, and
"h323-setup-time=" for RADIUS.
- 788 -