AudioCodes Mediant 4000 SBC - Page 823

CHAPTER51 Reporting Information to External Party
Mediant 4000 SBC | User's Manual
Field Description
■ "MESSAGE"
■ "BENOTIFY"
■ "SERVICE"
Note:
■ The field is included in the default CDR.
■ The field is applicable to all CDR Report Types.
■ The field is applicable only to SBC signaling CDRs.
■ The default field title is "SIPMethod".
■ The maximum number of characters for Syslog tabular alignment is 10.
SIP Remote
Tag
[446]
Displays the 'tag' parameter of the SIP From / To headers that is received by
the device in the incoming SIP message . The field value is a string of up to 100
characters.
Note:
■ The field is optional and can be included in the CDR using the Gateway
CDR Format and SBC CDR Format tables.
■ The field is applicable to all CDR Report Types, but it may not be added to
some Report Types in all call scenarios.
■ The field is applicable only to SBC signaling and Gateway CDRs.
■ The maximum number of characters for Syslog tabular alignment is 20.
SIP
Termination
Description
[430]
Displays the description of the SIP call termination reason. The field value is a
string of up to 70 characters and is set to one of the following:
■ SIP Reason header, if exists, for example: SIP ;cause=200 ;text="Call
completed elsewhere".
■ If no SIP Reason header exists, the description is taken from the reason
text, if exists, of the SIP response code, for example: "417 Unknown
Resource-Priority".
■ If no reason text exists in the SIP response code, the description is taken
from an internal SIP response mapping mechanism. For example, if the
device receives a SIP response "422", it sends in the CDR "422 Session
Interval Too Small method" as the description.
Note:
■ The field is included in the default CDR.
■ The field is applicable only to "CALL_END" CDR Report Types.
■ The field is applicable only to SBC signaling and Gateway CDRs.
■ The default field title is "SipTermDesc".
■ The maximum number of characters for Syslog tabular alignment is 26.
SIP
Termination
Reason
[429]
Displays the SIP reason for call termination. The field value is a string of up to
12 characters and is set to one of the following:
■ "BYE"
■ "CANCEL"
■ SIP error codes (e.g., "404")
Note:
■ The field is included in the default CDR.
■ The field is applicable only to "CALL_END" CDR Report Types.
- 790 -