Need help?Do you have a question about the Audison bit Tune and is the answer not in the manual?
General| Brand | Audison |
|---|---|
| Model | bit Tune |
| Category | Recording Equipment |
| Language | English |
Essential instructions and warnings before using the bit Tune for safe operation.
Details of all items included in the bit Tune product package.
Physical dimensions of the bit Tune unit.
Specifications and mounting guidelines for HSM and LPM microphones.
Detailed description of all connectors and indicators on the bit Tune's front panel.
Detailed description of all connectors and controls on the bit Tune's rear panel.
Explanation of the various controls and LEDs on the bit Tune's front control panel.
Details on the HSM microphone's components, functions, and installation.
Details on the LPM microphone's components, functions, and installation.
Instructions for powering the bit Tune and its on/off operation.
Diagrams showing how to connect the bit Tune with various PC configurations.
Diagrams illustrating the connection of HSM and LPM microphones to the bit Tune.
Diagrams showing various audio input signal connections to the bit Tune.
Diagrams illustrating various audio output signal connections from the bit Tune.
Step-by-step guide for installing the bit Tune PC software and drivers.
Procedure for removing the bit Tune PC software and associated drivers.
How to launch the bit Tune software for analysis without PC connection.
How to launch the bit Tune software for calibration with a processor.
Displays connection status and information for the bit Tune and connected processor.
Customizes information for measurements, included in the final report.
Overview of file operations: New, Load, Save, Save as, Registration, Updates, Exit.
Introduction to the measurement tools available in the bit Tune software.
Automatically creates a PDF report of installer, client, and measurement data.
Access to microphone calibration, connection settings, company info, and language.
Automates time delays, equalization, and output levels for Audison bit processors.
Provides quick access to measurement functions like Oscilloscope, RTA, and Generator.
Analyzes audio source characteristics: output voltage, distortion, and frequency response.
Step-by-step process for calibrating the HSM microphone for accurate measurements.
Checks correct polarity connection of speakers or amplifiers using the LPM microphone.
Procedure for electrical phase detection with an Audison bit processor.
Procedure for electrical phase detection in an audio system without a processor.
Calibrates amplifier sensitivity levels when using an Audison bit processor.
Verifies signal levels in systems with pre-set amplifier sensitivity and a processor.
Calibrates amplifier sensitivity levels in systems without Audison bit processors.
Automates equalizer and time delay calibration for Audison bit processors.
Sets time delays for speakers using an Audison bit processor separately.
Measures acoustic effect and frequency response of audio systems using RTA.
Performs RTA calibration for audio systems without Audison bit processors.
Monitors vehicle battery voltage during engine start or audio system operation.
Using the oscilloscope to graph electrical signals and analyze electronic device functioning.
Checks if OEM sources require a speaker load for correct operation.
Checks activation of Hi-Level inputs with automatic ignition (ART).
Checks audio signal and noise on analog or digital audio lines by listening.
Identifies sources of electromagnetic interference acoustically via the internal speaker.
Troubleshoots connection loss or unresponsiveness between bit Tune and PC.
Resolves issues where the PC does not recognize the bit Tune during driver installation.
Procedure for replacing the internal BNC input fuse if it blows.
Steps for upgrading the bit Tune firmware and PC software.
Procedure to re-program firmware using Rescue Mode after failed updates.
Guide for replacing the internal power supply fuse.
To Next Page