Autonics TK Series User Manual

6 Parameter Settings and Functions
96 © Copyright Reserved Autonics Co., Ltd.
6.6.3 Communication parity bit [PAR4 → PRTY]
Parity bit is a data communication method that adds an additional bit to each character in
transmitted data as an indicator used to verify data loss and corruption. This parameter is used
to enable or disable the parity bit option.
Setting
Description
NONE Disables parity bit.
EVEN
Sets the total bits with signal value of 1 as even numbers.
ODD Sets the total bits with signal value of 1 as odd numbers.
Setting
group
Parameter Setting range
Factory
default
Unit
PAR4 PRTY NONE / EVEN / ODD NONE -
6.6.4 Communication stop bit settings [PAR4 → STP]
You can set the number of bits to mark the end of a transmitted data string.
Setting
Description
1
Sets end of data string to 1 bit.
2 Sets end of data string to 2 bits.
Setting
group
Parameter Setting range
Factory
default
Unit
PAR4 STP 1 / 2 2 bit
6.6.5 Response wait time settings [PAR4→ RSwT]
Set a standby time to mitigate communication errors when communicating with a slow master
device (PC, PLC, etc.). Once a standby time is set, the controller will respond after the defined
standby time.
Setting
group
Parameter Setting range
Factory
default
Unit
PAR4 RSwT 05 to 99 20 ms
Shorter standby times can cause communication errors in the master device.

Autonics TK Series Specifications

General

Brand	Autonics
Model	TK Series
Category	Temperature Controller
Language	English