Autronica Autroprime 2 - Page 95

Unit Configuration
Configuration Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME2-CONFIG/EGB, Rev. A, 2013-04-03,
Autronica Fire and Security AS
Page 95
5.13.5.5 Set Testbit to 1
This command is used for test purposes.
From the External Interfaces Menu (5.13.1), perform the
following:
 Use the arrow down button to select MODBUS, then press Enter.
 Use the arrow down button to select Set Testbit to 1, then press
Enter.
The following message will appear:
“Test message transmitted”.
5.13.5.6 Assign Unique MODBUS Indexes
This command is used for test purposes.
From the External Interfaces Menu (5.13.1), perform the
following:
 Use the arrow down button to select MODBUS, then press Enter.
 Use the arrow down button to select Assign Unique MODBUS
Indexes, then press Enter.
 To confirm the setting, press Enter once more.

