System Parameter
Name
TLV Name Impact
The system checks whether a reset is necessary to obtain
a new IP address due to a change in the values of the
parameters L2Q or L2QVLAN. This TLV is ignored if:
• the value of USE_DHCP is 0 and the value of IPADD is
not 0.0.0.0, or
• the Application Type is not 1 (Voice), or
• the Unknown Policy Flag (U) is set to 1.
MCIPADD Proprietary Call
Server TLV
MCIPADD will be set to this value if it has not already
been set.
TLSSRVR and
HTTPSRVR
Proprietary File
Server TLV
TLSSRVR and HTTPSRVR will be set to this value if
neither of them have already been set.
L2Q Proprietary 802.1 Q
Framing
The default L2Q is set to the value of this TLV. No change
is made to the current L2 tagging, but the new default
value is used on the next reboot.
• If the 802.1Q Framing value is 1, L2Q will be set to “1”
(on)
• If the 802.1Q Framing value is 2, L2Q will be set to “2”
(off)
• If the 802.1Q Framing value is 3, L2Q will be set to “0”
(auto)
Proprietary - PoE
Conservation TLV
This proprietary TLV can initiate a power conservation
mode. The phones that support this will turn the phone
backlight and the backlight of an attached Button Module
on or off in response to this TLV. But, the 9670G
deskphone puts the display backlight into low-power mode
and does not turn off the backlight.
Extended Power-Via-
MDI
Power conservation mode is enabled if the received binary
Power Source value is 10, and power conservation mode
is disabled if the received binary Power Source value is
not 10. Power conservation mode is enabled even if the
phone is not powered over Ethernet because the phone
sends information about the power source that it is using
in a TIA LLDP MED Extended Power-Via-MDI TLV. The
power management system intends to conserve local
power also.
Administering Deskphone Options
March 2018 Administering Avaya 9608/9608G/9611G/9621G/9641G/9641GS IP Deskphones H.
323 115
Comments on this document? infodev@avaya.com
To Next Page
Loading...
