Chapter 4: Network requirements
Network requirements
Network assesment
Perform a network assessment to ensure that the network has the capacity for the expected data
traffic and voice traffic, and can support jitter buffers and the following types of applications as
required:
• H.323
• DHCP
• HTTP/HTTPS
• LLDP
• RADIUS
You also need QoS support to run VoIP on your configuration. For more information, see
Administering UDP port selection on page 40.
To use the 9600 Series IP deskphones to reach the network through a Virtual Private Network 15
(VPN), seeVPN Setup Guide for 9600 Series IP Telephones, 16-602968.
Hardware requirements
• Category 5e cables that conform to the IEEE 802.3af-2003 standards, for LAN powering.
• TN2602 or TN2302 IP Media Processor circuit pack. For increased capacity, install a TN2602
circuit pack even if you have a TN2302 IP Media Processor circuit pack.
• TN799C or D Control-LAN (C-LAN) circuit pack.
Important:
IP telephone firmware Release 1.0 or later requires TN799C V3 or greater C-LAN circuit
packs. For more information, see the Communication Manager Software and Firmware
Compatibility Matrix on the Avaya support site https://support.avaya.com/
CompatibilityMatrix/Index.aspx.
To ensure that you administer the appropriate circuit packs on your server, see Communication
Manager Administration on page 39.
March 2018 Administering Avaya 9608/9608G/9611G/9621G/9641G/9641GS IP Deskphones H.
323 26
Comments on this document? infodev@avaya.com
To Next Page
Loading...
