Avaya G430 - Page 157

• If these fields are set to n (disabled), at the SAT, enter display feature-
access-codes and gather the following FAC information:
- Contact Closure Open Code
- Contact Closure Close Code
- Contact Closure Pulse Code
- Auto Route Selection (ARS) Access Code1
- Auto Route Selection (ARS) Access Code2
- ARS FAC
- CAS Remote Hold/ Answer Hold-Unhold Access Code
3. Look up the location of the gateway, as follows:
a. At the SAT, enter list media-gateway to get the gateway’s number.
b. At the SAT, enter display media gateway number, where number is the
gateway number you obtained in Step
a on page 0 .
This provides you with the location field value.
• If the gateway has an administered location, at the SAT, enter display
locations number, where number is the administered location number.
If there is an ARS entry for the given location, you must use this value
exclusively in the SLS data set.
• If there is no administered location, at the SAT, enter display feature-
access-codes and gather the FAC information listed in Step 2 on
page 0 .
Feature Access Code field descriptions
Related topics:
Contact Closure Open Code on page 157
Contact Closure Close Code on page 158
Contact Closure Pulse Code on page 158
Auto Route Selection (ARS) Access Code 1 on page 158
Auto Route Selection (ARS) Access Code 2 on page 158
ARS FAC on page 158
CAS Remote Hold/Answer Hold-Unhold Access Code on page 158
Contact Closure Open Code
FAC used to open a contact closure relay. Contact closures control electrical devices remotely.
Users use an FAC to activate electrical devices such as electrical door locks. If Contact
Standard Local Survivability (SLS)
Administering Avaya G430 Branch Gateway October 2013 157