Avaya G430 - Page 221

See Logging filter configuration on page 224.
Related topics:
Disabling logging system messages to a log file on page 221
Deleting current log file and opening an empty log file on page 221
Log file message format on page 222
Disabling logging system messages to a log file
Procedure
Enter set logging file disable.
Gxxx-001(super)# set logging file disable
Done!
Deleting current log file and opening an empty log file
Procedure
Enter clear logging file
Gxxx-001(super)# clear logging file
Done!
Related topics:
Example display of log file messages on page 221
Example display of conditions defined for the file output sink on page 222
Example display of log file messages
The show logging file content command displays the messages in the log file. Note
that the user enabling the log sees only entered commands with a user-level no higher than
the user’s privileges. A user with read-only privileges does not see entered commands having
a read-write user level.
Example
Gxxx-001
(super)# show logging file content
<190>Apr 21 16:28:32 149.49.77.11 -NoTag: -NoUTC 2009 055 1
mediagateway.g430 | 0 coldStart[BOOT-Informational: System boot up
from cold reset, ID=N/A
<187>Apr 21 16:28:32 149.49.77.11 -NoTag: -NoUTC 2009 525 1
mediagateway.g430 | 0 MSY-TRPMAJNA[VOICE-Error: No Call Controller
Found, ID=N/A
<190>Apr 21 14:30:25 149.49.77.11 -NoTag: -NoUTC 2009 965 1
System logging
Administering Avaya G430 Branch Gateway October 2013 221