Avaya G430 - Page 287

Configuring a track list on page 287
Object tracking configuration workflow on page 288
Configuring a simple object tracker
Procedure
1. Use the track id rtr command to specify the RTR to be tracked.
Enter a number from 1 to 50 as the unique ID for this object tracker.
For example:
Gxxx-001(config)# track 1 rtr 5
Gxxx-001(config-track rtr 1)#
2. Use the description command to enter a description for the object tracker.
For example:
Gxxx-001(config-track rtr 1)# description “track rtr-5”
Done!
Configuring a track list
Procedure
1. Use the track id list command to enter track list configuration mode, to specify
the unique ID of the track list from 1 to 50, and to specify how to calculate the state
of the track list.
The calculation can be either a Boolean or a Threshold calculation.
Note:
If you do not specify how to calculate the state of the track list, it is calculated by
default using the Boolean AND argument. This means that the list is up if all
objects are up, and down if one or more of the objects are down.
Examples:
Gxxx-001(config-track list 10)# description “track list rtr-5 and rtr-6”
Done!
Gxxx-001(config)# track 10 list boolean or
Gxxx-001(config-track list 10)#
2. Use the description command to enter a description for the track list.
3. Use the object command to add an object tracker to the list.
Note:
The object tracker can be a simple one tracking a single RTR, or a track list.
WAN interfaces
Administering Avaya G430 Branch Gateway October 2013 287