For example:
Gxxx-001(config-track list 10)# object 1
Done!
4. Repeat step 3 to add as many object trackers as you require, up to a maximum of
50.
5. If you specified a Threshold method of calculation in step 1, use the threshold
count command to enter the threshold values.
For example, use the following command to specify that:
• The state of the object tracker will change from down to up if 2 or more hosts
are up, and
• The state of the object tracker will change from up to down if 1 or less hosts
are up
•
Gxxx-001(config-track list 10)# threshold count up 2 down 1
Done!
Note:
Object trackers operate indefinitely once they are defined. To stop the operation
of an object tracker, use the no track command to delete the object tracker.
Object tracking configuration workflow
rtr
type
frequency
dscp
next-hop
source-address
wait-interval
fail-retries
success-retries
rtr-schedule
track id rtr
description
track id list
description
object 1
.
.
object n
threshold count
Tasks for maintaining object tracking
Using the show commands, you can display RTR and Object Tracking configuration, and
enable RTR and object tracking logging to a CLI terminal.
WAN interfaces
288 Administering Avaya G430 Branch Gateway October 2013
Comments? infodev@avaya.com
To Next Page
Loading...
