Avaya G430 - Page 289

Task Command
Display RTR configuration values, including
all defaults, for a specific RTR operation or
for all RTR operations.
show rtr configuration
Display the global operational status of the
RTR feature, for a specific RTR operation or
for all RTR operations.
show rtr operational-state
Display tracking information. show track
For more information about these commands, see Summary of object tracking configuration
commands on page 296 or the Avaya Branch Gateway G430 CLI Reference
Related topics:
Viewing RTR and object trackers logging on page 289
Example of tracking a single remote device on page 290
Example of tracking a group of devices on page 291
Viewing RTR and object trackers logging
Procedure
1. Enter set logging session enable to enable logging to the CLI terminal.
For example:
Gxxx-001# set logging session enable
Done!
CLI-Notification: write: set logging session enable
2. Use the set logging session condition saa to view all RTR messages of
level Info and above.
For example:
Gxxx-001# set logging session condition saa Info
Done!
CLI-Notification: write: set logging session condition saa Info
3. Use the set logging session condition tracker command to view all
object tracker messages of level Info and above.
For example:
Gxxx-001# set logging session condition tracker Info
Done!
CLI-Notification: write: set logging session condition tracker Info
WAN interfaces
Administering Avaya G430 Branch Gateway October 2013 289